Maintains performance from −43°C to +130°C
Petrolatum Tape System
Petrolatum Corrosion Protection Tape
A cold-applied, permanently flexible petrolatum wrap for steel assets, irregular details and maintenance conditions where practical surface preparation matters.
Overview
System role and composition
Primary conformable corrosion protection wrap
- Non-woven carrier impregnated with a stabilized petrolatum compound
- Used with petrolatum primer, profiling mastic and matching outer protection where required
Key advantages
Approved product and system characteristics
Statements below apply only to this product or stated system and must be read with the listed conditions and qualifiers.
No hardening in cold conditions or softening at high temperature within the stated range
Conforms to irregular geometries including flanges, weld seams and bolt clusters
St2 manual surface preparation may be used; abrasive blasting is not required for the stated system
Resistant to acids, alkalis, salts and microbial attack
Service life exceeding 10 years under severe operating conditions
Cold-applied and resistant to hardening, cracking and embrittlement
Typical applications
Where this solution is considered
- Flanges, valves and bolt clusters
- Storage tank annular plate edges
- Pipeline fittings and weld seams
- Above-ground and buried steelwork where specified
Typical Sizes and Packaging
- Thickness: 1.0–1.5 mm
- Width: 50–300 mm
- Length: 10 m/roll
Product formats, packaging and available grades may vary by application and order requirements. Please confirm the current configuration with our team.
Installation overview
Confirm the complete procedure before work begins
- Inspect the substrate, geometry, existing coating and service environment.
- Prepare the surface to the requirement stated for the selected system.
- Apply the compatible primer or profiling material where the system calls for it.
- Install the primary tape with the specified overlap, tension and termination treatment.
- Add compatible outer protection where required, then inspect continuity and terminations.
Matching components
This overview supports early evaluation. The current TDS and approved project procedure remain the controlling installation documents.
Gallery
Product and application views
Related applications
Continue from product to asset
Verified related project evidence
Technical documents
Request the documents relevant to your evaluation
Product catalog, technical data, safety information and installation guidance are supplied according to the selected product and application.
Content source: Zhuohuang Technical Data Sheets UAE 2026 (primary); Zhuohuang Product Catalogue UAE 2026 (secondary).
Frequently asked questions
Is abrasive blasting always required?
No. St2 manual surface preparation may be used for the stated system. The final method must reflect the asset condition and approved procedure.
Can it wrap irregular details?
Yes. The material is intended to conform around flanges, weld seams and bolt clusters when installed as a complete specified system.
Technical inquiry
Confirm the right configuration for your asset
Share the asset type, geometry, existing coating, operating environment and documentation requirements.
Discuss This Product